How to Connect a DrayTek Vigor2860 router to AAPT NBN
Posted by on 07 July 2015 03:07 PM

This guide will show you how to configure the Vigor2860 router to connect to AAPT NBN connection.

Note: This guide only applies to AAPT and may not apply to other NBN providers. You will need to check with the NBN provider for the configuration parameters required for step 2.


Step 1 - Connect to the router Admin page

Use your internet browser to login to the router web interface

(The default IP address for the router is

Default username and password are as given below:

User name: admin

Password: admin


Step 2: Configure WAN Interface


Go to Internet access>>General Setup configuration menu

            1). Select WAN2

            2). Select Enable: “Yes” and click “OK”



The router will now restart.


Step 3: Configure WAN Internet Access


After the router has restarted log into the router again and go to the admin page.

Go to WAN >> Internet Access configuration menu.

            1). Select access mode to “Static or Dynamic IP” for WAN2

            2). Click on “Details Page”




           3). Select “Obtain an IP address automatically” or “Specify an IP Address” based on the details received from ISP

           4). Enter static IP address, subnet mask and gateway address if you have selected “Specify an IP Address” option

           5). Click Ok




         Router will restart again.



Step 4: Check the connectivity

After the router has restarted log into the router again and go to the admin page to check your connection.

Go to Online Status>>Physical Connection menu

If you see WAN2 status as all green it means your NBN connection is connected successfully. You can now check your internet access.



(3 vote(s))
Not helpful

Comments (0)