New Router in Bridge mode Unable to Obtain IP Address from iiNet Network
Posted by Rudi Tan on 18 July 2016 11:58 AM


Enabling Bridge Mode in the Vigor130 results in no DHCP response when connected to iiNet network. The Vigor130 works fine in MPOA+DHCP client mode but not in Bridge mode.


iiNet lock the device MAC address for the device connected to the network for authentication. It can take up to 4 hours for IPoE to refresh the MAC to IP binding session.

To overcome this, disconnect the router from the iiNet network connection and wait for approximately 4 hours for the cache to clear on the iiNet network before re-conneting the device.



(6 vote(s))
Not helpful

Comments (0)