If your Access Point (AP) is connected to multiple subnets, you may
set up multi-SSID to separate the wireless clients to different
network. This document demonstrates how to set up your AP with
multi-SSID. Here is an example of AP connecting to a router ...
This video will show how to configure 802.1Q VLAN trunk between a
DrayTek router and an access point to set up multiple IP subnets in
the access point. This configuration can be used to isolate wireless
users to the required subnets. For example you may w...
If you wish to extend the wireless range using two access points and
also want to use the same SSID, AP Bridge-Point to Point mode can be
used. Here is an example of two AP900 (AP Bridge-Point to Point)
connecting to each other.
"AP Bridge - Point to Po...
This guides shows how to use Vigor AP in Bridge-Point to Multi-Point
mode. Using this mode, VigorAP will connect to other VigorAPs which
operate in the same mode, and their wired clients will be able to
access one another through the 2.4G wireless connect...
Some customers may lose Wi-Fi access in the Vigor Wi-Fi routers and
access points due to the WLAN ON/OFF/WPS switch on the side of the
router or access point being accidentally pressed. To overcome this
DrayTek have added a feature in routers and Accsss P...
This document will guide you through on how to extend wireless
coverage to two locations using two Vigor AP810 and a Vigor 2830n as
your wireless router.
Supported Models: Vigor AP 710, Vigor AP810, Vigor AP 910c, Vigor
AP902, Vigor 2760n/Vn, Vigor 2832...
HOW TO SETUP LAN AND WAN CONNECTIONS VIA WIRELESS WITH 2 APS
NETWORK TOPOLOGY
PARAMETERS
LAN A : A subnet of 192.168.1.X (Local LAN)
LAN B : A subnet of 192.168.100.X (Internet)
AP902 :
LAN A in AP-Bridge-WDS mode
LAN B in AP mode, and has w...